The figure below shows selected code sections that must be considered when designing this type roof.įigure R802.5. Ridge boards shall be at least 1 inch nominal thickness and not less in depth than the cut end of the rafter (IRC section R802.3).Ĭhapter 8 of the International Residential Code (IRC) prescribes the elements for a type of roof frame known as a 'compression roof'. Ridge boards can only be used in roofs with slopes from 3 in 12 up to 12 in 12. Ridge beam sizing is based on the span of the beam between supports, and the amount of roof load supported by the beam.Ī ridge board is a non-structural member that serves as a prop for opposing rafters to rest against and connect to. Our manufacturing process creates uniform and predictable products, all with a limited lifetime warranty. From window openings to garage door headers, Microllam® LVL is a versatile solution that supports heavy loads without worry. For example: An 12 inches deep an LVL beam can span up to 20 feet (12÷12× 20 20 foot). Ridge beams are required by code if the roof slope is less than 3 in 12 (IRC section R802.3). A versatile performer in a wide range of structural applications. Calculate LVL beam span on the rule of thumb for estimating the span of LVL manufactured beam which is to multiply the depth in feet by figure 20, resulting figure is span of LVL beam. A Ridge Beam and a Ridge Board are both located at the ridge but they serve very different purposes for very different applications.Ī ridge beam is a structural member used to support the ends of the rafters at the ridge, transferring it's loads to posts or gable end walls.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |